EDF Health

Selected tag(s): 3Ts

Lead from a new “lead-free” brass faucet? More common than you’d hope

Tom Neltner, J.D. is the Chemicals Policy Director and Lindsay McCormick is a Project Manager.

[pullquote]Until NSF/ANSI 61 standard is updated to reduce or eliminate lead leaching, users must extensively clean and flush new brass fixtures before use and make a short flush standard practice for older fixtures.[/pullquote]

During this past year, we undertook a pilot project to tackle the problem of lead in drinking water at child care facilities. As part of the effort, we collected 250 mL samples (about 8 ounces of water) from every drinking water fixture, as recommended in the Environmental Protection Agency’s (EPA) 3Ts guidance for schools and child care facilities. We replaced 26 faucets that exceeded our action level with new brass faucets that were labeled “lead-free” and complied with NSF/ANSI 61 standard for drinking water system components.[1] To our surprise, when we sampled the faucets a few days after replacement, the lead levels were higher– between 9 and 10 ppb – on three of the new faucets.

The increase left us scratching our heads. Federal law allows a drinking water fixture to be labeled “lead-free” if the amount of lead in wetted surfaces[2] averages less than 0.25% (down from the 8% limit between 1986 and 2014). However, it isn’t clear how much this amount might contribute to levels of lead in water. To explore this issue, we contacted the supplier who said its product was certified under NSF/ANSI 61 and, therefore, not likely the source. The supplier suggested the source could be from existing upstream valves or from disturbing the plumbing. We could not rule these other possibilities out.

A study by Virginia Tech’s Jeff Parks on three models of new NSF/ANSI 61 certified brass faucets found similar results and concluded that even newly manufactured “lead-free” faucets may not meet the 1 ppb limit that the American Academy of Pediatrics (AAP) recommends for schools.

Read More »

Posted in Drinking water, Lead / Also tagged , , , , , , , , | Authors: / Comments are closed

EPA Updates its 3Ts Guidance for Reducing Lead in Drinking Water

Lindsay McCormick, is a Project Manager. Tom Neltner, J.D., is the Chemicals Policy Director.

Earlier this month, EPA released its updated 3Ts for Reducing Lead in Drinking Water Toolkit, which provides guidance for schools and child care facilities seeking to ensure children are safe from lead in water.  The new 3Ts – an update to the agency’s 2006 guidance – is now a web-based toolkit that includes modules, customizable templates, and factsheets.

Overall, the new toolkit is an improvement.  While the protocol itself is largely the same, the new toolkit is more user friendly and written for the non-technical audience, making it more likely that school and child care staff will use it.  EPA has also reframed the toolkit from “Training, Testing, and Telling” to “Training, Testing, and Taking Action” – placing more emphasis on the critical step of addressing lead sources than the previous version.  “Telling” is now integrated throughout the entire toolkit to highlight the importance of communication at every step. The agency has also developed a helpful flushing best practices factsheet, which is a topic that often causes considerable confusion.

In EDF’s June 2018 report on our pilot of 11 child care facilities, “Tackling lead in water at child care facilities,” we recommended EPA update its 2006 guidance to address four key gaps.  The agency has made progress on the two most important of those but leaves the other two unresolved. The most important change to the guidance is that the agency has removed the 20 parts per billion (ppb) action level and instead recommends action whenever there are “elevated lead levels.” While EPA does not define an elevated lead level, a deep dive into the appendix suggests that levels over 5 ppb warrant follow-up. The updated guidance also puts a greater emphasis on the identification of lead service lines (LSLs) and includes LSL replacement as a permanent control measure, though not as an explicit recommendation. Further, the agency did not update the protocol to deal with challenges posed by aerator cleaning and hot water heaters.  Below we explore each of these issues in further detail. Read More »

Posted in Drinking water, Health policy, Lead, Public health, Regulation / Also tagged , , , , | Comments are closed