EDF Health

Should EPA grant industry’s hypocritical request to now address 1,4-dioxane’s risks as a byproduct, it must meet a number of conditions

Richard Denison, Ph.D., is a Lead Senior Scientist.

Environmental Defense Fund (EDF) submitted extensive comments last week to the Environmental Protection Agency (EPA) that raise numerous serious concerns with EPA’s draft risk evaluation for the likely human carcinogen 1,4-dioxane.  EDF’s comments are available here.

I want to use this post to highlight one of the many issues:  For years, the industry has urged EPA not to include 1,4-dioxane’s presence as a byproduct in various formulated products within the scope of its risk evaluation for the chemical; see comments specific to 1,4-dioxane from the American Cleaning Institute, Procter & Gamble, and the Household & Commercial Products Association; and more general comments urging exclusions for byproducts and “trace levels” from the American Chemistry Council and the Consumer Specialty Products Association Comment.

Not surprisingly, the Trump EPA’s draft risk evaluation for 1,4-dioxane did just that, a major problem EDF objected to on legal and scientific grounds.

Then in late July, the industry abruptly reversed itself.  A comment letter submitted to EPA by the American Cleaning Institute and the Grocery Manufacturers Association says the industry has changed its mind and is now calling on EPA to include 1,4-dioxane’s presence as a byproduct as a condition of use in its risk evaluation.

Why the shift?  At this late hour it has dawned on the industry groups that any final action by the agency on the chemical that excludes 1,4-dioxane’s presence as a byproduct as a condition of use in its risk evaluation will not preempt states from acting to regulate this condition of use.

The industry’s hypocrisy aside, if EPA decides to grant this industry request, which has arrived long after EPA initiated the risk evaluation process, EPA should do so only subject to conditions that are critical to meet if its decision and risk evaluation are to maintain any semblance of credibility:

  • EPA needs to use its mandatory information authorities to require the submission and development of relevant information on the presence of 1,4-dioxane as a byproduct in industrial, commercial and consumer materials and products, as input into a revised draft risk evaluation.
  • EPA must promptly make all such information it receives public, subject only to redactions of information claimed confidential by the submitters that EPA determines meet all applicable requirements of TSCA section 14. It should be noted that much of the relevant information will constitute health and safety information that is not eligible for protection under section 14 and must be made public.
  • EPA needs to carefully and thoroughly develop and fully integrate an analysis of the potential exposures and risks arising from the presence of 1,4-dioxane as a byproduct into all aspects of its risk evaluation, given that inclusion of the presence of 1,4-dioxane as a byproduct will affect all of the exposure and risk estimates EPA has examined in the current draft risk evaluation.
  • EPA must publish a revised draft risk evaluation for public comment, providing the public with ample time to review the new draft and develop meaningful comments.
  • EPA must subject its revised draft risk evaluation to full peer review by the Scientific Advisory Committee on Chemicals (SACC), providing the committee with ample time to review the new draft and develop meaningful comments.

Any credible evaluation of the contribution to 1,4-dioxane’s overall health and environmental risks due to its presence as a byproduct must be based on complete, reliable information that is publicly accessible, and must reflect input from both the public and expert peer reviewers.  For EPA to do anything less will simply cast yet more doubt on its trustworthiness and independence from industry interests.

 

Posted in Health policy, Health science, Industry influence, Regulation / Tagged , , | Comments are closed

Taking on the lead challenge: State and community action accelerates across the country

Sam Lovell, Project Manager and Tom Neltner, J.D., Chemicals Policy Director.

In January, we reported on the tremendous progress made by states and communities in 2018 to replace lead service lines (LSLs) – the estimated 6.1 million lead pipes across the country that connect homes and other buildings to the water main under the street. At that time, our tracker stood at 95 communities and 16 states working to replace LSLs.

Half a year later, and the total number of communities (including municipalities and water utilities) EDF has learned of that are leading the way has swelled to 181.[1]

  • 7 communities located in Massachusetts, Michigan, Oregon, South Dakota, Washington, and Wisconsin have publicly announced that they completely replaced all known LSLs.
  • 108 communities have publicly set a goal of eliminating LSLs on public and private property, totaling more than 381,000 LSLs. Nearly ¾ of these communities are served by the investor-owned utility, American Water’s, operations in Missouri (34 communities), Indiana (27 communities), and Pennsylvania (19 communities). For the remaining states, Wisconsin is leading the way with 11 communities followed by Michigan with five; Colorado and Massachusetts with two; and Arizona, Arkansas, Montana, New Jersey, and Washington each with one.
  • 66 communities are publicly taking steps to replace LSLs but have not yet set a goal of full replacement. These communities include 15 in Wisconsin; 12 in New York; 11 in Illinois; seven in Michigan and Massachusetts; five or fewer in Colorado, Iowa, Kentucky, Minnesota, New Jersey, Ohio, Pennsylvania, Rhode Island, Texas, Vermont, and Virginia; and Washington, D.C.

Read More »

Posted in Drinking water, Lead / Tagged , , , , | Comments are closed

Lead from new “lead-free” brass faucets? An update on progress

Tom Neltner, J.D. is the Chemicals Policy Director and Lindsay McCormick is a Program Manager.

[Update: On 10/23/19, the NSF committee responsible for revising NSF 61 tentatively agreed to tighten the limits on lead leaching from new faucets and drinking fountains. The committee will move forward with a formal vote and, if approved, will receive public comment on the proposed changes.]

Last year, we discovered and reported in a blog, that some new brass faucets that meet existing standards and are labelled “lead-free” can still leach significant amounts of lead into water in the first few weeks of use. Here, we answer some questions that have come up and provide an update on efforts to revise the NSF/ANSI 61 standard to better protect and inform consumers.

Last November, the committee responsible for revising the NSF/ANSI 61 standard convened a group to consider an optional certification for faucets that meet a more protective limit. A study of more than 500 models of faucets showed that 73% of faucets leach less lead into water and can meet a limit that is five times more protective for children. However, currently there is no easy way to identify these “lower lead” models. The optional certification would enable consumers, schools, and child care facilities to identify and purchase faucets that leach less lead to drinking water.

Unfortunately, as described later in this blog, representatives of the brass faucet manufacturers have worked to block the optional certification. As of August 2019, the committee has not decided whether to move forward with a proposal for the optional certification to receive public notice and comment. If the committee fails to move forward, we anticipate that some major retailers that sell brass faucets and other major buyers such as school districts and builders would use their leverage to set higher standards in their purchasing specification that favors models performing better on the NSF/ANSI 61 lead leaching test.

Read More »

Posted in Drinking water, Lead / Tagged , , , | Authors: / Comments are closed

Denver Water proposes innovative plan to remove an estimated 75,000 lead service lines in 15 years

Lindsay McCormick, is a Program Manager. Tom Neltner, J.D., is the Chemicals Policy Director.

Update (12/18/19): EPA approved Denver Water’s Lead Reduction Program on December 16, 2019. The utility will start implementing the program in 2020. 

Yesterday, Denver Water’s board approved its proposed “Lead Reduction Program Plan” to fully replace the estimated 75,000 lead service lines (LSLs) in their system within 15 years.  The plan is an innovative solution that will remove the primary source of lead within Denver Water’s system, while avoiding the use of orthophosphate that can further exacerbate nutrient pollution problems in rivers, streams and oceans, an issue EDF’s Ecosystems team is working hard to solve.

As proposed, Denver Water would fund full replacement of LSLs through water rates, bonds and sales of new connections to the system, hydropower production and other sources rather than have individual property owners contribute.  In addition, the utility’s proposal to provide filters to residents until their LSLs are replaced represents a model other communities should consider based on the effectiveness of their ongoing pilot.  Before implementing the plan, Denver Water will need to receive approval from the Environmental Protection Agency (EPA).

Read More »

Posted in Drinking water, Lead, Public health / Tagged , , , | Authors: / Comments are closed

Chemours asks FDA to suspend its approved uses of PFAS in food packaging

Tom Neltner, J.D.Chemicals Policy Director

Politico reported today that Chemours notified the Food and Drug Administration (FDA) that it had officially abandoned its three approved food packaging uses of per- and poly-fluorinated alkyl substances (PFAS) and asked the agency to withdraw its Food Contact Substance Notifications (FCNs) for those uses. We do not know with certainty what prompted Chemours to abandon its PFAS products for food packaging or whether they were ever used in the United States. Based on past experience, we anticipate that FDA will grant the request.

This action takes us one step closer to reducing people’s exposure to these chemicals linked to an array of health risks posed by PFAS at extremely low levels. Additionally, the action should serve as an incentive for other companies to do the same.

Chemours also has FCNs for six PFAS uses in repeat-use food contact articles like gaskets and seals. The company apparently has not asked the agency to abandon these uses. We suspect that the PFAS-treated gaskets may still be in service even if it has stopped treating new gaskets with the chemicals.

Read More »

Posted in FDA, Food, Health science, PFAS / Tagged , , , | Read 2 Responses

Trump EPA caves again to industry demands on new chemicals, and workers pay the price

Richard Denison, Ph.D., is a Lead Senior Scientist.

Isocyanates are nasty chemicals, including when they are left over as residuals after manufacturing other chemicals.  Here are the kinds of risks they pose, according to the National Institute for Occupational Safety and Health (NIOSH):

Isocyanates are powerful irritants to the mucous membranes of the eyes and gastrointestinal and respiratory tracts.  Direct skin contact can also cause marked inflammation.  Isocyanates can also sensitize workers, making them subject to severe asthma attacks if they are exposed again. There is evidence that both respiratory and dermal exposures can lead to sensitization.  Death from severe asthma in some sensitized subjects has been reported.

In prior reviews of new chemicals under the Toxic Substances Control Act, EPA has repeatedly indicated that “[i]socyanate exposure has been identified as the leading attributable cause of work-related asthma, and prevalence in the exposed workforce has been estimated at 1-20 percent.”

Both NIOSH and EPA have raised even greater concern over activities involving spray application of chemicals containing isocyanates.  In 2006, NIOSH issued a rare alert calling for workers to undergo medical surveillance and wear high-efficiency respirators and gloves when engaged in such activities.

Even in the recent past, when reviewing new chemicals containing isocyanate residuals, EPA has typically (1) issued a consent order subjecting the company submitting the chemical for review to multiple conditions in order to limit workplace inhalation exposures to the residuals, and (2) followed up with a Significant New Use Rule (SNUR) that extends those conditions to other companies, requiring them to notify EPA prior to engaging in any activity that exceeds those workplace limits.  And the only case since TSCA was amended in 2016 where EPA found a new chemical “presents an unreasonable risk” – as opposed to the more common, lower-bar finding that it “may present an unreasonable risk” – involved residual isocyanates present after manufacture of two new chemicals.

In such cases EPA has imposed some combination of three types of conditions on manufacture of such chemicals:  prohibitions on activities that could generate inhalable forms of the chemical and result in inhalation exposures; strict requirements for the use of high-efficiency respirators and gloves; and a strict limit on the amount of isocyanate residuals allowed to be present in the new chemical, typically in the range of 0.1% to 0.2%.

So it is quite disturbing to see how EPA has dealt with the most recent such new chemical for which EPA has issued its final decision – which requires that companies employ NONE of these protections.  Read More »

Posted in Health policy, Industry influence, Regulation, TSCA reform, Worker safety / Tagged , , , | Comments are closed