Tom Neltner, J.D. is the Chemicals Policy Director and Lindsay McCormick is a Project Manager.
[pullquote]Until NSF/ANSI 61 standard is updated to reduce or eliminate lead leaching, users must extensively clean and flush new brass fixtures before use and make a short flush standard practice for older fixtures.[/pullquote]
During this past year, we undertook a pilot project to tackle the problem of lead in drinking water at child care facilities. As part of the effort, we collected 250 mL samples (about 8 ounces of water) from every drinking water fixture, as recommended in the Environmental Protection Agency’s (EPA) 3Ts guidance for schools and child care facilities. We replaced 26 faucets that exceeded our action level with new brass faucets that were labeled “lead-free” and complied with NSF/ANSI 61 standard for drinking water system components.[1] To our surprise, when we sampled the faucets a few days after replacement, the lead levels were higher– between 9 and 10 ppb – on three of the new faucets.
The increase left us scratching our heads. Federal law allows a drinking water fixture to be labeled “lead-free” if the amount of lead in wetted surfaces[2] averages less than 0.25% (down from the 8% limit between 1986 and 2014). However, it isn’t clear how much this amount might contribute to levels of lead in water. To explore this issue, we contacted the supplier who said its product was certified under NSF/ANSI 61 and, therefore, not likely the source. The supplier suggested the source could be from existing upstream valves or from disturbing the plumbing. We could not rule these other possibilities out.
A study by Virginia Tech’s Jeff Parks on three models of new NSF/ANSI 61 certified brass faucets found similar results and concluded that even newly manufactured “lead-free” faucets may not meet the 1 ppb limit that the American Academy of Pediatrics (AAP) recommends for schools.